Introduction
Installation of the Seat Back Tech Plate for Ford F-Series and Ranger is simple and quick. Reminder - its easier to install your mounts and accessories to the panel before you attach it to the seat back.
Install Time & Difficulty
20 - 30 minutes per side
Easy
Tools
7/16 Wrench
3/8 Socket
Ratchet
9/64 Allen Key
5/32 Allen Key
Installation
1. Headrest Block Preparation
- Attach the foam pieces to the headrest mounting blocks.
- Peel off the foam backing, place inside the blocks, and trim excess.
- Repeat for the second headrest block.
2. Upper Bracket Installation
- Position the upper bracket on the headrest posts.
- Use 4 12-24 button head screws and 4 black washers to loosely fit the bracket.
- Center the bracket using the gap in the upper slot.
- Tighten the screws once aligned.
3. Seat Teardown
- Move the seat forward to access the back.
- Remove the two elastic loops under the seat.
- Unzip the two zippers holding the seat fabric.
- Disconnect the wiring harness by pulling it down gently.
- Unloop the elastic and secure the upholstery out of the way.
4. Bottom Bracket Installation
- Use 2 panel clips and 2 1/4-20 bolts to mount the lower bracket.
- Align the panel clips with the seat holes, ensuring the flat side faces out.
- Loosely attach the lower bracket and tighten with caution to avoid breaking the clips.
5. Tech Plate Test Fitting & Adjustments
- Drop the upholstery back down and test fit the tech plate.
- If needed, adjust the upper bracket by loosening the screws and lowering it slightly.
- Re-tighten the upper bracket after adjustments.
6. Reinstall Upholstery
- Reattach the seat upholstery, starting with the zippers and moving down to the elastic loops.
- Pop the wire clips back into place.
7. Tech Plate Installation
- Attach the tech plate to the upper bracket using 3 12-24 screws.
- Start with the middle screw and let it hang before attaching the other two.
- Secure the bottom of the plate using quarter-20 button head screws and nuts.
- Tighten all screws to finish the installation.
For further assistance, contact us via email, social media, or phone.
Comments
0 comments
Please sign in to leave a comment.