Introduction
Installation of the Seat Back Tech Plate Kit for RAM is very straight forward and simple. We don't have a specific installation video for RAM just yet, but follow along in the F-150 video and the installs are similar. If you have any questions, contact us.
Install Time & Difficulty
20 - 30 minutes per side
Easy
Tools
7/16 Wrench
3/8 Socket
Ratchet
9/64 Allen Key
5/32 Allen Key
Installation
1. Headrest Block Preparation:
- Apply foam to the headrest mounting blocks:
- Peel the backing off the foam.
- Place the foam inside the mounting block.
- Trim the excess foam as needed.
- Repeat for the second headrest mounting block.
2. Upper Bracket Installation:
- Attach the upper bracket to the headrest posts using:
- 2 headrest mounting blocks.
- 4 12-24 button head screws.
- 4 black washers.
- Align the bracket with the headrest posts:
- Center the upper bracket on the seat, using the upper slot for reference.
- Tighten the button head screws.
3. Seat Teardown:
- Move the seat forward to access the back.
- Detach the two elastic loops from under the seat.
- Unzip the two zippers holding the seat back fabric.
- Remove the wiring harness by pulling it out of its clip.
4. Lower Bracket Installation:
-
Mount the lower bracket using:
- 2 panel clips (align the holes with the seat structure).
- 2 1/4-20 bolts.
-
Install the lower bracket:
- Ensure the flat side of the panel clips faces outward.
- Tighten the bolts carefully (avoid over-tightening).
5. Tech Plate Test Fitting and Adjustment:
- Test fit the tech plate by holding it in place.
- Adjust the upper bracket:
- If necessary, loosen and lower the upper bracket slightly to ensure proper alignment.
6. Reinstall the Upholstery:
- Zip up the fabric and reattach the elastic loops.
- Reinsert the wiring harness into its clip.
7. Tech Plate Installation:
-
Mount the tech plate:
- Attach the plate to the upper bracket using 3 12-24 screws (start with the middle screw).
- Attach the plate to the lower bracket using the 1/4-20 button head screw and nuts.
-
Tighten all screws to ensure the tech plate is securely mounted.
Video Install Guide
Comments
4 comments
Not sure how the installation for the RAM is anything like the F150 aside from the headrest mount. The only thing to attach the clips to for the bottom bracket is the metal bar going from one side of the seat to the other. There is no way to install this kit with it there without drilling through the metal brace. For the RAM kit I advice you to not purchase until 1. The company comes out with a proper installation guide or 2. They make longer bracket so the bolt can make it through.
Hey Sherman,
Apologies for the slow response on our end, just stumbled across your comment. You are absolutely correct, we can do better on the installation guide. We had hoped to have our 2019+ Ram 1500 tester back in house by now to film the installation guide. As long as you have a 2019+ Ram 1500, and you received PN104121 then you have the right kit and it will fit. Most folks don't realize you have to dig deeper than the first layer of upholstery. There is a layer of upholstery held in by a J-channel that has to be removed as well, then everything will bolt up perfectly.
If you haven't already, send us an email to support@builtrightind.com and I'll send you some picture that will be helpful.
-Matt Homes
Customer Service Manager
Builtrightind.com
any updates on this question?
a
Please sign in to leave a comment.