104086 | Dash Mount | Ford F-150 & Raptor 2024+ Narrow Tray

Introduction

Installation is very straight forward. The laser cut and CNC formed bracket attaches to the tray located above the dash using the included hardware kit.

NOTE: If you happen to break a plastic factory clip during install, no worries, we've got you covered. Send us an email at support@builtrightind.com and we will get you squared away.

Install Time & Difficulty

30 - 60 minutes

Medium

Tools

Plastic trim tool or small prying tool

7mm socket

Drill with correctly sized bits (1/16th, 3/8th)

Hook tool (optional)

Installation

1: Remove the Speaker Grill

• Use a plastic trim tool to carefully pry up the center speaker grill.
• Tip: Perform this step in a warm environment to prevent clips from breaking.

 2: Remove the Plastic Tray

• Use a 7mm socket to remove the two screws securing the plastic tray.
• Before removing the tray completely, place the bottom bracket of the dash mount into position.
• Center the bracket and mark five holes to be drilled:
  • Two holes in the center of the small slots at the bottom (⅜" recommended for adjustment).
  • Three holes on the front face (closest to the driver, not visible when seated).

3: Remove the Plastic Trim Piece

• Use a trim tool or hook tool to carefully remove the plastic trim piece you just marked.
• Disconnect the center channel speaker wiring harness as you pull up the trim.
• Set the trim piece (with attached speaker) aside.

4: Drill the Mounting Holes

• Drill the five marked holes:
  • Three smaller holes (about 1/16") along the front of the plastic trim.
  • Two ⅜" holes in the center of the lower slots.
• Set the trim piece aside once the holes are drilled.

5: Install the Lower Support Plate

• Locate the four bolts in the tray that line up with the holes in the yellow zinc plated support plate:
  • Two 7mm bolts near the windshield.
  • Two smaller screws on the steel dash support.
• Loosen the 7mm bolts and remove the two dash support screws.
• Slip the lower support plate into place and tighten all four bolts securely, keeping the factory bolts centered in the bracket’s clearance holes.

6: Reinstall the Plastic Tray & Speaker

• Reposition the plastic tray with the center speaker attached.
• Reconnect the speaker wiring harness.
• Press the trim piece back into place; ensure the threaded inserts in the lower support bracket are visible through the holes you drilled.
• Reinstall the speaker grill.

7: Secure the Dash Mount Bracket

• Use the provided washer and bolts through the two lower holes. These bolts provide the mount’s main strength.
• Use the three thread-forming screws to secure the dash mount’s front face to the dash tray. Do not overtighten.
  • These front screws reduce vibration but do not bear weight.

8: Attach the Top Plate

• Configure the dash top plate with any desired mounts/accessories.
• Use the six included screws to attach the top plate to the bottom bracket.
  • Start all screws loosely before tightening them down.
• Tighten all six screws until snug, ensuring their faces are flush with the top plate.

• Installation Complete!

• Your BuiltRight Industries Dash Mount is securely installed and ready for use.