Introduction
This is a relatively simple install, requiring only minor drilling and assembly. The result is an incredibly sturdy, AMPS-compatible mounting plate for all of your valuable equipment.
Install Time & Difficulty
15 - 20 minutes
Medium
Tools
Trim tool/ prying tool
7mm Socket
Pick tool
1/4" Drill Bit
3/8" Wrench
1/8" Allen Key
Instructions
With Dash Tray
1. Remove dash tray and the rubber mat inside of it. You may need to use a pick or pry tool to remove. The rubber mat will not be reused.
2. Remove material from the dash tray (hole saw or otherwise) to allow access to the bolt that is normally under the dash tray.
3. Remove the screw that is below the dash tray (that is mounting the dash plastics to the structure of the dash).
4. Place dash tray back in.
5. Bolt lower portion of dash mount into the tray using the long stainless screw and 1" spacer.
6. Mount the top plate loosely using the flat head 10-32 screws to ensure fitment in the tray.
7. Remove the top plate.
8. Mark 4 holes on the dash tray to be drilled.
9. Remove the tray.
10. Drill 4 other mounting holes in the dash tray.
11. Use 4 x 10-32 button head screws (screw head on the bottom of the tray to minimize protrusion into the dash), 4 x 10-32 nuts and 4 x #10 washers to mount the lower portion of the dash mount to the tray.
12. Place the tray with the lower portion of the dash mount mounted to it back into the dash.
13. Secure the tray/dash mount to the dash using the 1” spacer and long stainless screw.
14. Mount the top plate to the lower and the install is complete.
Without Dash Tray
1. Remove the rubber mat inside of the dash tray area.
2. Remove the screw that is mounting the dash plastics to the structure of the dash.
3. Bolt the lower portion of the dash mount into the tray using the long stainless screw and the 1” spacer.
4. Mount the top plate loosely using the flat head 10-32 screws to ensure fitment in the tray.
5. Remove the top plate.
6. Mark 4 holes on the dash tray to be drilled.
7. Remove the lower portion of the dash mount.
8. Drill the 4 holes to fit the 10-32 well nuts.
9. Place the 4 well nuts into the holes.
10. Place the lower portion of the dash mount back into the tray.
11. Secure the lower portion using the long stainless screw and the 1” spacer and the 4 10-32 button head screws.
12. Mount the top plate to the lower and the install is complete.
Comments
0 comments
Please sign in to leave a comment.