106113 | Cybertruck License Plate Relocation | Tesla Cybertruck 2024+

Introduction

Follow along in our below linked install guide for the installation of the Cybertruck License Plate Relocation Kit. If you have any questions, please contact us.

Install Time & Difficulty

10 - 20 minutes

Easy

Tools Needed:

• Ratchet with an extension
• 10 mm socket
• Pick tool (or small screwdriver)
• Two included Allen keys

Installation 

1. Remove the Tow Hook Cover:

• Locate the plastic cover on the front tow hook with a rubber surround.
• At the top of the cover, you will see two small openings.
• Use a pick tool or small screwdriver to press down on both sides, freeing the cover.
• Pull the trim piece off and set it aside for reinstallation later.

2. Loosen the 10 mm Bolt:

• Locate the 10 mm bolt near the tow hook.
• Use your ratchet and 10 mm socket to loosen the bolt (do not remove it entirely).
• Slip the mounting bracket into place underneath the bolt, ensuring the washer remains on the outside of the bracket.

3. Tighten the Mounting Bracket:

• With the bracket in place, tighten the 10 mm bolt to secure it.
• Make sure the bracket is aligned parallel to the front of the tow hook.

4. Reattach the Tow Hook Cover:

• Take the plastic cover that was removed earlier and replace it onto the tow hook, making sure it fits snugly.

5. Install the License Plate Bracket:

• The license plate bracket has multiple slots, allowing you to adjust the position of the plate.
  • Example setup: Align the bracket to tuck the plate up and over the front of the vehicle.
• Use the two larger bolts from the hardware kit and attach the bracket to the mounting bracket.
  • Insert the first bolt with a washer, followed by the second bolt, and finger-tighten both.
• Adjust the plate bracket to your preferred position and then tighten the bolts using the included Allen key.

6. Install Your License Plate:

• If desired, you can use the BuiltRight license plate frame for a sleek finish.
• Place your license plate onto the bracket.
• Use the included fasteners and washers to attach the plate.
  • Note: The use of washers (not included) depends on your state's  plate hole size.
• Tighten the fasteners using the Allen key.

Installation Video