Introduction
Follow along in our below linked install guide for the installation of the 102071 panel. Installation is covered in a segment of this video. If you have any questions, please contact us.
The installation for the RAM 4th gen bedside racks have changed a bit based on customer feedback. The aluminum 'dogbone' mounts have been replaced by spacers to provide more room for error during drilling. See our written installation guide (link below) for complete details.
Install Time & Difficulty
60 - 90 minutes
Hard
Tools
3/8” Socket and Wrench
9/16” Socket
5mm Allen Key
Flat head screw driver for prying
Impact driver or power drill
3/8” drill bit
Smaller drill bit for pilot hole
Exacto or Utility Knife
Rivet nut installation tool (optional)
Painters Tape (optional)
Instructions
Please click the following link for a .pdf of latest version of this installation.
Video Install Guide
Note, this installation has changed slightly since the video was filmed, based on feedback from customers. The above PDF is the most up to date version of the installation instructions.
Comments
1 comment
The installation video on the rear bed rack was unbelievably good and detailed. Matthew pointed out the impacts of bed liner on the fastener holes, as well as cautioning not to overtighten the fasteners on the bed light. Well done.
Please sign in to leave a comment.