Introduction
Follow along in our below linked install guide for the installation of the 102082 panel. Installation is covered in a segment of this video. If you have any questions, please contact us.
Installation of the Tacoma Bedside Rack System is our easiest ever. We worked hard to keep the design simple, requiring the fewest number of fasteners and brackets, which will not only save time, but minimizes opportunity for failure.
Install Time & Difficulty
10 - 15 minutes
Easy
Tools
T30 Torx bit
5/32 Allen wrench.
Instructions
1. Using a T30 torx bit, you'll loosen the bolts securing the utility rail to the bedside.
2. Removing the rear two will make space to slip the rear panel under the rail before reinstalling (loosely) the two bolts.
3. Next, remove the front two bolts and slide the front panel under the rail before reinstalling those two bolts.
4. If applicable, secure the rear panel using the bolts holding the trim or cubby panel in place and then tighten the utility rail bolts.
Comments
0 comments
Please sign in to leave a comment.