Introduction
Installation of the Tundra Bedside Rack System is our easiest ever. We worked hard to keep the design simple, requiring the fewest number of fasteners and brackets, which will not only save time, but minimizes opportunity for failure.
Install Time & Difficulty
10 - 15 minutes
Easy
Tools
T30 Torx bit
T40 Torx bit
5/32 Allen wrench.
Installation
1. Prepare the Bed:
- Remove the tie-downs located in the corners of the bed.
- Remove the track system by undoing all screws using the T30 and T40 Torx bits.
- There's a push rivet next to the second rearmost screw. Once all screws are removed, use a tool to remove the push rivet holding the track.
2. Mount the Rear Panel:
- Reinsert the push rivet through the channel and into the rear panel to hold it in place.
- Align the rear panel against the bedside.
- Loosely install the three bolts at the top rail using the included hardware.
- Reinstall the tie-down in the rear with its two bolts, but keep them loose for now to allow adjustments.
3. Mount the Front Panel:
- Move to the front panel.
- Like the rear panel, hold it up under the rail and install the three top bolts loosely.
- Reinstall the front tie-down and leave it loose for now.
4. Tighten Everything Down:
- Once everything is in place and aligned, go around and tighten all the bolts on the panels and tie-downs securely.
- Repeat process on opposite side
Comments
0 comments
Please sign in to leave a comment.