102114 | Bedside Rack System - 4pc Kit | Jeep Gladiator (2020-2023)

Introduction

The BuiltRight Bedside Rack System for the Jeep Gladiator mounts directly to the factory Trail Rail system or using our Utility Rail System (coming soon). Non-invasive installation keeps OEM Trail Utility Rail in it’s original location, ensuring that it’s load capacity isn’t reduced and preserving stock rail location/spacing for current and future accessories. Simply place the T-Slot nuts into the rail, move the panel into place and use the included hardware to fasten the panel to the rail. Larger panels will also use a lower mounting point, near the tie-down loop, for additional rigidity.

Install Time & Difficulty

15 - 30 minutes

Medium

Tools

3/8" Socket

7/32 Allen wrench

Ratchet

Masking tape

Installation

1. Prepare the 3/8 Channel Nut:

   • Place a piece of tape on one side of the 3/8 inch channel nut.
   • From underneath the vehicle, locate the bed light wiring harness and the factory tie-down loop.
   • Position the channel nut where you’ll insert the bolt from above, ensuring it lines up with the hole in the bed.

2. Adjust Trail Rail Alignment (if needed):

   • If you have the Mopar Trail Rail system, check if it is perfectly aligned with the bed.
   • Lift the panel into place and ensure the rubber bumper is firmly pressed against the bed to prevent rattling.
   • If misaligned, use a crescent wrench to slightly tweak the panel tab to make the bumper fit snugly.

3. Prep the Hardware at the Top of the Panel:

   • Use a 1/4-20 bolt with washer at the top of the panel.
   • Start threading the bolts loosely into place without fully tightening.

4. Install the Channel Nuts:

   • With the panel loosely mounted, position the channel nuts horizontally in the trail rail.
   • Slip the channel nut into the rail at a slight angle and rotate it to a 45-degree angle to lock it in place.
   • Ensure the channel nut is fully seated by checking its angle.

5. Align and Tighten the Panel:

   • Align the panel's large slot at the bottom with the channel nut installed earlier.
   • While tightening the top bolts, make sure the bottom channel nut remains properly aligned.
   • Tighten everything but leave some flexibility for small adjustments.

6. Install the Rubber Bumper:

   • Install the rubber bumper in one of the slots (typically the area nearest the wheel well) to ensure the panel is spaced away from the bed.
   • Secure the bumper with the small push clips.

7. Install the Lower Bolt:

   • Insert the spacer between the panel and the bed.
   • Push the lower bolt and washer through, ensuring the panel is pinned tightly at the bottom.
   • Snug the bolt but do not overtighten.

Final Steps:

• Ensure all bolts and hardware are secure but allow for small adjustments before final tightening.
• Check that the panel does not move or vibrate.
• Remove any tape used to hold the channel nuts in place.
• Verify that the rubber bumper is securely pressed against the bed and that no movement occurs when the panel is pushed.

Repeat on remaining panels, and youre done!

Video Install Guide