Introduction
This CNC machined aluminum plate replaces the boring black plastic cover in the bed of a Jeep Gladiator that isn’t equipped with the factory power outlet. Add a bit of a personalized look with a simple installation using the holes that are already in place from the factory!
Install Time & Difficulty
5 minutes
Easy
Tools
5mm Allen wrench
Installation
1. Pop out existing plastic bed plug location cover.
2. Place a bolt through the bed plug plate and thread a rubber wellnut until it is nearly snug against the bed plug. The flange (flat part) of the rubber wellnut will be flat against the back of the bed plug plate. Leave it slightly loose.
3. Repeat for all 4 holes
4. Place the bedplug into its location with the rubber wellnuts in the 4 holes.
5. While pressing the bedplug against the bedside, tighten the 4 bolts until snug. There is no need to overtorque these, the rubber will expand and keep the plate securely attached.
You're done!
Comments
0 comments
Please sign in to leave a comment.