Introduction
By following the steps below, you can ensure a secure and convenient installation. The result is an incredibly sturdy, AMPS-compatible mounting plate for all of your valuable equipment.
Install Time & Difficulty
15 - 30 minutes
Easy
Tools
1/8" Allen Key
Phillips Head Screwdriver
Instructions
1. Begin by removing the rubber mat located in the tray of Jeep's dashboard.
2. Identify the two screws located on either end of the try. Carefully remove these screws and set them aside as they will not be needed for the rest of the installation.
3. Take the two small plastic pieces provided with your dash mount kit. Position each plastic piece on the correct side of the tray. Use the included longer Phillips head screws to secure each plastic piece in place.
4. Place the large metal top plate over the installed plastic pieces. (Note - the fit is snug, you may need to use the screws to nest the plate properly in place). Use the included hardware to secure the top plate. If the top plate does not fit perfectly, you may need to adjust the position of one of the end pieces by moving it side to side until the holes align perfectly.
Installing Accessories
1. The mount is designed as a three-piece unit, making it easy to remove the top plate.
2. Remove the top plate, attach your accessories to it, and then replace the top plate.
3. This design eliminates the need to reach around or risk dropping screws into your dashboard.
Once all the components are securely installed and aligned, the installation is complete. Your cell phone mount is now ready for use.
Comments
0 comments
Please sign in to leave a comment.