102010 | Bedside Rack System | Ford F-150 & Raptor (2021+)

Introduction

Installation of our Ford Bedside Rack Systems is very straight forward, making use of factory mounting locations with zero modification to your truck. Getting the panels installed should take a matter of minutes with simple hand tools and the included hardware. But, deciding how you'll situate your gear (the fun part) can take as long as you'd like.

Install Time & Difficulty

30 - 45 minutes

Easy

Tools

T30 Torx bit

Instructions

Rear Panels

1. Locate and remove the rear tie down points using the T30 Torx bit. Retain this hardware.
2. Remove the 4 bolts that hold the Boxlink plate on the rear bedside. If your truck doesn’t have standard Ford F-150 Boxlink plates and has four non-threaded holes, use the included thread-forming screws to create threads.
3. Loosely mount the rear panel using the 4 Boxlink mounting holes. The factory or BuiltRight Boxlink plates can be mounted on top of the bedside rack mount.
4. Align panel and loosely reinstall tie down hoop. The tie down will mount on top of the BuiltRight MOLLE panel.
5. Tighten all bolts and place push pin and rubber bumper on the lower front portion of the panel to eliminate any movement.
6. Repeat on opposite side

Front Panels

1. Locate and remove the 4 bolts and Boxlink plate on the front of the bedside. If your truck doesn’t have standard Ford F-150 Boxlink plates and has four non-threaded holes, use the included thread-forming screws to create threads.
2. Loosely mount the rear panel using the 4 boxlink mounting holes. The factory or BuiltRight Boxlink plates can be mounted on top of the bedside rack mount.
3. Tighten all bolts.
4. Repeat on opposite side

You're done!

Video Install Guide

Related Content

Attaching Milwaukee Packout Mounts can be seen in the video below.