Introduction
The Bridge Panel for Ford F-150 & Raptor (2015+) is the ultimate add-on for your existing Bedside Rack MOLLE Panel System. The all-new Bridge Panel spans the gap between your front and rear BuiltRight MOLLE panels and adds up to 60% more mounting surface on each side of your bed. No matter what you're hauling, it's built to optimize cargo management without getting in the way of most bed covers. Installation is quick and requires no modifications–just bolt it on and get to work.
Install Time & Difficulty
10 - 55 minutes
Medium
Tools
T30 TORX (to loosen Bedside Rack fasteners)
Ratchet/Impact Driver (hand torque)
5/32 Allen Key
Installation
1. Loosen front and rear T30 torx fasteners that secure each existing bedside rack to your bed. This will allow some lateral and slight vertical adjustment to make sure the horizontal 1/4" slots are aligned.
2. Slide leading and trailing edge of the bridge panel behind the bedside racks, securing the panel loosely in place with 5x 1/4-20 allen head fasteners.
3. One bridge panel is loosely secured and aligned, tighten down all 5 fasteners connection the bridge panel to the front and rear bedside racks.
4. Finally, re-tighten down the 4x T30 bolts holding both the front and rear panels ot the Boxlink features in the ned. If using power tools, save the finally torquing to hand tools, you bed is made of aluminum after all.
Comments
0 comments
Please sign in to leave a comment.