Introduction
Installation of the Rear Seat Bottom Divider Panel is quick and simple, resulting in new organizational opportunities for your vehicle.
Install Time & Difficulty
10 minutes
Easy
Tools
None- just your hands!
Instructions
1. Lift the Driver's rear seat bottom by lifting up after pulling up on the heat singe release located at the hinge point of the seat on the driver's side of the pull paddle patch underneath the seat bottom.
2. If your lower seat frame came with plastic fascia/trim piece, use a trim pry tool to remove.
3. Use supplied hardware (carriage bolts, washers and locking wing-nuts) in kit to bolt Seat Bottom Divider MOLLE panel into place
4. Use 1/4" hardware or MOLLE Nuts to secure gear mounts and attachment to the divider plate on either the front or back of the panel, or both!
Prototyping Video
Comments
0 comments
Please sign in to leave a comment.