102172 | Bedside Accessory Rail - Single Side | Ford F-150, Raptor (2015+) & Super Duty (2017+)

 The BuiltRight Bedside Accessory Rail (BAR) is the most modular truck bedside mounting platform available. 

What’s Included:

• 2  Support Brackets (
• 1  Extrusion Rails 
• Hardware Kit:
  • 1/4"-20 Button Head Screws
  • T-slot Nuts
  • Box Link Hardware (bolts, optional fresh hardware)
  • Washers
  • Plastic End Caps with Push-In Clips
  • Allen key for 1/4"-20 screws
  • Torx bits (for Box Link bolts)

Note: You may reuse your factory Box Link hardware if desired. If you use fresh hardware, applying anti-seize is recommended.

Tools & Additional Materials Needed:

• Ratchet and extension
• Appropriate Torx bits (as provided)
• Tape measure
• Anti-seize compound (optional but recommended)

Installation:

1. Prepare the Bedside:

1. Locate the Box Link mounting points in your truck bed.
2. Optionally, insert fresh Box Link bolts with a touch of anti-seize if you are not reusing OEM hardware.
3. Loosely install the 2 bottom Box Link bolts in each bracket location (without the bracket for now) to help measure the spacing and hold the brackets in temporarily.

2. Measure Bracket Spacing:

1. Measure the center-to-center distance between the two sets of Box Link bolts where the brackets will mount. *Note this measurement as it will help you position the brackets on the extrusion before final installation.
2. Also measure the clearance to ensure the extrusion is not biased too far forward or backward. Adjust as needed to maintain desired alignment.

3. Pre-Assemble the Rail & Brackets:

1. Slide the required T-slot nuts into the extrusion’s channel.
2. Place a bracket at one end of the extrusion (this will be your rear bracket).
3. Loosely thread in the 1/4"-20 button head screws with washers through the bracket into the T-slot nuts.
4. Measure from the end of the extrusion to match the previously recorded spacing.
5. Snug the bracket once spaced correctly and aligned.
6. Repeat the process for the front bracket, ensuring both brackets match the measured spacing.
7. Ensure both brackets face the correct orientation (matching the orientation in the bed).

4. Install Plastic End Caps:

1. Press the plastic end cap onto the extrusion end.
2. Secure it with the provided push-in tree clips for a finished look.

(You can do this step after mounting as well, but it’s easier beforehand.)

5. Final Installation in the Truck:

1. Apply anti-seize to the Box Link bolts if desired.
2. Lift the assembled rail (extrusion + brackets) into position, aligning bracket holes with the pre-installed bottom Box Link bolts.
3. Start by threading in at least one top bolt on each bracket to hold the assembly in place.
4. Insert the remaining bolts and washers into the brackets.
5. Tighten all bolts evenly, ensuring the rail sits level and properly aligned.
6. Do not overtighten; snug is sufficient since these bolts thread into the Box Link inserts.

Finishing Up:

• Double-check all hardware for proper tightness.
• Confirm the rail is aligned as desired.
• Your BuiltRight Industries Bedside Accessory Rail is now ready for use. Outfit it with compatible accessories to customize your truck’s cargo management system.

Installation Video