Introduction
The Bulkhead Accessory Rail for Ford F150 & Raptor is ridiculously rigid, lightweight and a perfect modular storage solution that allows you to secure our steel MOLLE panels, QuickFist riser mounts, other accessories and even mountain bike fork mounts to the back of your cab wall. This is a very simple install that results in a ton of extra utility for your truck bed.
Install Time & Difficulty
10 - 15 minutes
Easy
Tools
T30 Torx tool or bit
4-6" Extension
Impact driver, Socket Set or Screwdriver
5/32 Allen wrench
Instructions
1. Connect the two extrusion pieces using the included hardware and the connecting bracket. (This step has been omitted as we now supply a 1 piece horizontal extrusion)
2. Then, connect the two end brackets loosely.
3. Next, remove the tie-downs in either side of the bed using a T30 torx and move the BAR assembly into place. You make choose to replace the factory tie-downs but the BAR brackets can serve the same purpose.
4. Tighten brackets to bedside before tightening the hardware connecting the brackets to the rail itself.
Comments
0 comments
Please sign in to leave a comment.