102020 | Bedside Rack System 4 Panel Kit | Ford F-150 & Raptor (2009 - 2014)

Introduction

Installation of our Ford Bedside Rack Systems is very straight forward, making use of factory mounting locations with zero modification to your truck.

Install Time & Difficulty

45 - 60 minutes

Easy

Tools

T30 Torx

7/16" Socket

1/2" Socket

Ratchet or Impact Driver

Installation

1. Position the Panel

• Set the panel approximately in place before installing any clamps or mounts.

• This allows you to decide where to mount your accessories for easier access.

• Install the clamps or mounts now to save time later.

2. Assemble Bottom Bracket

• Attach the bottom bracket to the panel using the provided carriage bolts and nuts. The Longer angle of the bracket should be positioned on top 

• Ensure the bracket is securely mounted to the back of the panel.

3. Remove Factory Tie-Down

• Use a T30 socket to remove the factory tie-down from the bed.

4. Install the Panel

• Place the panel into position, ensuring the top edge is tucked behind the bed rail.

• Reinstall the factory tie-down using the two stock bolts but do not fully tighten them yet.

5. Install Bed Rail Clamps

• Place the two bed rail clamps at the top of the panel to secure the panel. These are available through us or through other vendors.

• Ensure the clamps are positioned correctly—clamping the back of the panel, not too high or too low.

• Once positioned correctly, tighten the clamps to hold the panel in place.

• Keep the panel level while tightening.

6. Final Adjustments

• Once the clamps are secure, finish tightening all the fasteners.

• Repeat for other 3 corners

Video Install Guide

Related Content

102023 | Bedside Rack System - Rear Panel | Ford F-150 & Raptor (2009 - 2014)

102025 | Bedside Rack System - Front Panel | Ford F-150 & Raptor (2009 - 2014)