104060 | Dash Mount (Standard) | Ford F-150 & Raptor (2021+)

Introduction

Installation is very straight forward. The laser cut and CNC formed bracket attaches to the tray located above the dash using five machine screws, included in the hardware kit. The five .25" holes used must be drilled by the user in the OEM tray. Should you choose to return to stock, the OEM rubber mat inside the tray conceals the holes.

NOTE: If you happen to break a plastic factory clip during install, no worries, we've got you covered. Send us an email at support@builtrightind.com and we will get you squared away.

Install Time & Difficulty

30 - 60 minutes

Medium

Tools

1/8" Allen Wrench

7mm Socket and Ratchet

3/8" Socket or Wrench

1/4" Drill Bit

Trim tool (optional)

Installation

1. Remove the Rubber Tray. Tape the edges of the plastic dash to protect from marring and scratches.

2. Remove the Center Channel Speaker Grille (if equipped): Use your fingertip or trim tools to pry up the grille. It is held in by eight plastic spring-loaded clips. Warm interior plastics are less brittle and easier to work with.

3. Remove the Screws. Use a 7mm socket to remove the two screws on either side of the center channel speaker. If no center channel speaker: Locate the screws in the same position on the flat tray.

4. Remove the Center Tray. Use trim tools to pry up the center tray, starting at the front edge. Work from front to back, prying straight up to avoid breaking clips.

5. Prepare for Dash Mount Installation. Mock up the dash mount in the tray and position it. Mark drill locations with tape or a small drill bit.

6. Drill Holes. Start with an 1/8-inch drill bit to create guide holes, and then switch to a 1/4-inch drill bit to enlarge the holes for mounting.

7. Install the Dash Mount by placing the dash mount into position. Insert screws with washers provided, securing them loosely at all five locations. Tighten screws from front to back to avoid warping the tray.

8. Secure the Dash Mount. Use a 3/8-inch wrench or socket to snug up all bolts. Ensure that the dash mount does not severely warp the tray.

9. Reinstall the Center Channel Speaker (if equipped). Plug in the speaker harness. Reinstall the speaker grille.

10. Reinstall the Center Tray. Align the tray with the clips and carefully work the front lip below the dash bezel. Clip in the forward-most clips first, then secure the rest.

11.  Remove any remaining tape from the dash. Reinstall the 7mm bolts on either side of the center channel speaker. Ensure all components are secure and in place.

Completion:

• Your installation is now complete. For any questions or feedback, please contact us via phone or email.

Video Install Guide