Introduction
The first product we ever engineered, the BuiltRight Industries Rear Seat Release was made to make your life easier. Installation of our Rear Seat Release takes just a few minutes using a T30 torx bit and something like a closed end wrench to release the seat latch.
This install guide works for the following part numbers: 100100, 100113, 100114, 100115.
Install Time & Difficulty
5 - 10 minutes
Easy
Tools
T30 Torx
Any close-ended wrench
Instructions
1. Lower seat back by lifting seat bottom to make space and then looping a box end wrench around the pin on the factory latch of the seat back.
2. Remove two T30 torx screws.
3. Install Rear Seat Release. The black bracket is installed ON TOP of the stock latch. No drilling is required for this install. If you have questions, please contact us.
4. Replace T30 screws and tighten.
Comments
1 comment
I had a 2010 F150 and the seat latch installed just like the video. I just purchased a 2026 and couldn't get the seat to release at all. What eventually worked was using the wrench to pull up on the pin, and while holding it up then pull the strap on the side of the seat to release the bottom portion back down and the back came down with it. Just an FYI
Please sign in to leave a comment.