The first product we ever engineered, the BuiltRight Industries Rear Seat Release was made to make your life easier. Installation of our Rear Seat Release takes just a few minutes using a T30 torx bit and something like a closed end wrench to release the seat latch.
Install Time & Difficulty
5 - 10 minutes
Any close-ended wrench
1. Lower seat back by lifting seat bottom to make space and then looping a box end wrench around the pin on the factory latch of the seat back.
2. Remove two T30 torx screws.
3. Install Rear Seat Release. The black bracket is installed ON TOP of the stock latch. No drilling is required for this install. If you have questions, please contact us.
4. Replace T30 screws and tighten.