102003 | Bedside Rack System - Driver Rear Panel | Ford F-150 & Raptor (2021+)

Introduction

Follow along in our below linked install guide for the installation of the 102003 panel. Installation is covered in a segment of this video. Hardware included. If you have any questions, please contact us.

Install Time & Difficulty

5 - 10 minutes

Easy

Tools

T30 Torx bit

Instructions

Rear Panels

1. Locate and remove the rear tie down points using the T30 Torx bit. Retain this hardware.
2. Remove the 4 bolts that hold the Boxlink plate on the rear bedside. If your truck doesn’t have standard Ford F-150 Boxlink plates and has four non-threaded holes, use the included thread-forming screws to create threads.
3. Loosely mount the rear panel using the 4 Boxlink mounting holes. The factory or BuiltRight Boxlink plates can be mounted on top of the bedside rack mount.
4. Align panel and loosely reinstall tie down hoop. The tie down will mount on top of the BuiltRight MOLLE panel.
5. Tighten all bolts and place push pin and rubber bumper on the lower front portion of the panel to eliminate any movement.

Video Install Guide

Related Content

102010 | Bedside Rack System | Ford F-150 & Raptor (2021+)

102002 | Bedside Rack System - Small Panel | Ford F-150/Raptor (2015-2021) , Ford F250 (2017-2021)

201102 | Mounting Bracket For Milwaukee PackOut System