102015 | Bedside Rack System - Large Panel | Ford SuperDuty (2017-2022)

Introduction

Follow along in our below linked install guide for the installation of the 102015 (Driver's Side) panel. Installation is covered in a segment of this video. Hardware included. If you have any questions, please contact us.

Install Time & Difficulty

10 - 15 minutes

Easy

Tools

T30 Torx

Ratchet or Impact Driver

Instructions

Rear Panels

1. Locate and remove the rear tie down points using the T30 Torx bit. Retain this hardware.
2. Remove the 4 bolts that hold the Boxlink plate on the rear bedside. If your truck doesn’t have standard Ford F-150 Boxlink plates and has four non-threaded holes, use the included thread-forming screws to create threads.
3. Loosely mount the rear panel using the 4 Boxlink mounting holes. The factory or BuiltRight Boxlink plates can be mounted on top of the bedside rack mount.
4. Align panel and loosely reinstall tie down hoop. The tie down will mount on top of the BuiltRight MOLLE panel.
5. Tighten all bolts and place push pin and rubber bumper on the lower front portion of the panel to eliminate any movement.
6. Repeat on opposite side

You're done!

Video Install Guide

Related Content

102014 | Bedside Rack System - 4pc Kit | Ford F-250, F-350 (2017-2022)

102016 | Bedside Rack System - Large Panel | Ford SuperDuty (2017-2022)

102002 | Bedside Rack System - Small Panel | Ford F-150/Raptor (2015-2021) , Ford F250 (2017-2021)