Introduction
Follow along in our below linked install guide for the installation of the 102402 kit. Installation for this kit is identical to the 5ft bed. If you have any questions, please contact us.
Install Time & Difficulty
10 - 20 minutes
Easy
Tools
T40 Torx
7/16 Wrench
3/8in Wrench
4mm Allen Wrench
Ratchet w/ extension
3/8in Socket
Instructions
1. Using a T40 torx bit, remove each of the tie down loops and set them aside.
2. Next, remove the rubber covers plugging the oval shaped holes in the bed.
3. Install the machined aluminum tie down mount blocks and brackets.
4. Install the rear panel and loosely bolt into place using OEM hardware.
5. Loosely install the front panel using OEM hardware.
6. Bolt the two panels together using the included stainless bolts.
7. Tighten all hardware and you're done.
Comments
2 comments
I have a 2022 Ranger with the Tremor package. There are no center tiedowns, but the holes are there. there is a spray-in bed coverage. will any of the above cause a problem with the installation?
Thanks Greg
Hey Greg,
The lack of center tie downs will NOT be an issue, we provide extra bolts in the kit for this very reason as Ford shorted them on the Rangers for a period of time. If any of your hardware is coated over with the bed coating, use a sharp razor blade at a los andle to the surface to cut/score the part to it doesn't tear or peel the coating as you remove it.
-Matt Homes
Customer Service Manager
BuiltRightInd.com
Please sign in to leave a comment.