Introduction
This is a relatively simple install, requiring no drilling. The result is an incredibly sturdy, AMPS-compatible mounting plate for all of your valuable equipment.
Install Time & Difficulty
10 - 20 minutes
Easy
Tools
1/8" Allen key
T15 Torx driver
Instructions
1. Using the T15 torx, remove the factory plastic Accessory Ready bracket from Ford and install the provided steel support bracket reusing the factory screws. These only need to be finger tight.
2. Next, pre-assemble the mounting platform and the feet on either end using an 1/8" Allen key.
3. You can used the provided VHB tape, place the dash mount in position.
4. Bolt the mount to the center steel support bracket, tighten to finger tight. Do not over tighten.
Comments
0 comments
Please sign in to leave a comment.