106101 | Bronco License Plate Mount | Ford Bronco (2021+) For Standard Plastic Bumper

Introduction

Installation of the BuiltRight Bronco License Plate Mount on the 2021+ Ford Bronco requires just a few simple tools and a couple minutes of your time. On the OEM standard plastic bumper, the bumper mounting bracket is secured to the bumper using a single bolt near the front tow hook location.

Skip to 6:45 in the Video Install Guide for the Standard Plastic Bumper.

Install Time & Difficulty

5 - 10 minutes

Easy

Tools

3/8" Ratchet with Extender

15mm Socket

4mm Allen Key (included)

3mm Allen Key (included)

Installation

1. Loosen the 15mm Bolt:

   • Locate the 15mm bolt above the tow hook. Loosen (but do not remove) this bolt enough to slip the bracket onto it with the bracket angled upwards.
   • Slide bracket on and adjust the bracket to the desired position (rotatable).

2. Tighten the 15mm Bolt:

   • Once the bracket is in place, tighten the bolt. You can adjust the positioning later if needed.

3. Attach the Backing Plate:

   • Position the backing plate on the bracket. It can be mounted higher, lower, or off to the sides depending on personal preference.
   • Use the 4mm Allen key to secure the backing plate with screws.

4. Install the License Plate:

   • Use longer bolts to mount the license plate onto the backing plate.
   • Use the 3mm Allen key to fasten the license plate screws. Start all screws loosely before fully tightening them.

5. Make Final Adjustments:

   • Before fully tightening, step back and ensure the license plate is straight and properly oriented.
   • Tighten all screws once satisfied with the positioning.

6. Optional Adjustments:

   • You can adjust the angle of the mounting bracket by loosening and repositioning it as needed.
   • Alternatively, you can pre-assemble the kit off the vehicle but may need to reconfigure based on final preferences.

Video Install Guide

Related Content

Adjusting the license plate mount and relocation bracket